Defects related emission and nanosecond optical power limiting in CuS quantum dots

We report optical and nonlinear optical properties of CuS quantum dots and nanoparticles prepared through a nontoxic, green, one-pot synthesis method. The presence of surface states and defects in the quantum dots are evident from the luminescent behavior and enhanced nonlinear optical properties measured using the open aperture Z-scan, employing 5 ns laser pulses at 532 nm. The quantum dots exhibit large effective third order nonlinear optical coefficients with a relatively lower optical limiting threshold of 2.3 J cm⁻², and the optical nonlinearity arises largely from absorption saturation and excited state absorption. Results suggest that these materials are potential candidates for designing efficient optical limiters with applications in laser safety devices.     

基于模式跳变的井下便携式高精度CH_4浓度监测系统设计

为了在矿井中实现快速、便携式的甲烷浓度检测,同时系统还具备高灵敏度及长的工作周期,设计了基于半导体激光器模式跳变的差分光学光谱吸收法,建立了井下甲烷浓度无线检测系统。系统利用调制电流使半导体激光器的输出波长发生模式跳变,从而获得了两个相近波长的激光,其中一个在甲烷的特征吸收峰上,而另一个基本不被吸收。实验中将两束光分别照射被测气室时,两束光的光强之差代入比尔朗伯定律即可求解气室内的甲烷浓度。实验结果显示,调制电流从20.0 mA增大到60.0 mA过程中,输出波长在电流达到48.3 mA时发生跳变,由1 650.888 nm改变为1 651.020 m。通过HITRAN光谱数据库可知,波长1 650.888 nm位置可作特征吸收峰,而波长1 651.020 nm适合作参考波长。在此基础上,对密闭容器内标准浓度的甲烷气体进行测试,采用H-BD5GD410-HC型便携式甲烷检测仪的测试数据作对比。两种检测结果相近,但随着浓度不断地增高,该系统的检测误差相对平稳,略优于甲烷检测仪。系统的检测误差均低于0.050%,在不采用昂贵的锁相器、检相电路的条件下,实现了精度优于0.10%的井下甲烷浓度检测。     

Response surface methodology toward the optimization of high-energy carotenoid extraction from Aristeus antennatus shrimp

High-energy assisted extraction techniques, like ultrasound assisted extraction (UAE) and microwave assisted extraction (MAE), are widely applied over the last years for the recovery of bioactive compounds such as carotenoids, antioxidants and phenols from foods, animals and herbal natural sources. Especially for the case of xanthophylls, the main carotenoid group of crustaceans, they can be extracted in a rapid and quantitative way with the use of UAE and MAE.     

基于波长调制-直接吸收光谱方法的CO分子1567 nm处谱线参数高精度标定

直接吸收光谱(DAS)可直接测量分子吸收率函数,并通过拟合吸收率函数确定待测气体参数.波长调制-直接吸收光谱(WM-DAS)在DAS基础上,结合了波长调制光谱(WMS)中谐波分析思想,利用傅里叶变换复现吸收率函数,可有效提高吸收率函数的测量精度.本文利用WM-DAS方法结合长光程气体吸收池,在室温低压条件下,对CO分子1567 nm处R5-R11近红外弱吸收谱线吸收率函数进行了精确复现,其拟合残差标准差低至3×10^-5,随后根据测得的吸收率函数对谱线的碰撞展宽、Dicke收敛以及速度依赖的碰撞展宽系数等光谱参数进行了高精度标定,并将其与高灵敏度的连续波腔衰荡光谱(CW-CRDS)测量结果进行了比较,实验结果表明该方法与CW-CRDS测量结果具有高度一致性,更具有系统简单、测量速度快、对环境要求低等优点.     

Curvature investigation in tapered fibers and its application to sensing and mode conversion

Non-adiabatic tapered fibers are basic photonic components used in a wide range of applications. Here we investigate a way to increase their utility through the controllable bending of one of their tapered sections. The experiments carried out explain, for the first time, the mechanics of this approach showing how these tapers can be used to build more sensitive sensors. Their use as highly efficient mode converters is also discussed.     

Mechanism of Insertion Reactions between Silylenoid H2SiLiF and GeH3R (R =F,OH, NH2): a Theoretical Study

Theoretical investigations on the insertion reaction mechanisms of three- membered-ring silylenoid H2 Si Li F with GeH 3R(R = F, OH, NH2) have been systematically carried out by combined density functional theory(DFT) and ab initio quantum chemical calculations. The geometries of all stationary points for these reactions were optimized using the B3 LYP method and then the QCISD method was used to calculate the single-point energies. The calculated results indicate that, there are one precursor complex(Q), one transition state(TS), and one intermediate(IM) which connect the reactants and the products along the potential energy surface. The insertion reactions of three-membered-ring silylenoid with Ge H3 R proceed in a concerted manner, forming H2RSi-Ge H3 and Li F. The calculated potential energy barriers of the three reactions are 29.17, 30.90, and 54.07 k J/mol, and the reaction energies for the three reactions are –127.05, –116.91, and –103.31 k J/mol, respectively. The insertion reactions in solvents are similar to those in vacuum. Under the same situation, the insertion reactions should occur easily in the following order: GeH 3-F GeH 3-OH GeH 3-NH2. The elucidations of the mechanism of these insertion reactions provided a new mode of silicon-germanium bond formation.     

Conventional vs. Microwave- or Mechanically-Assisted Synthesis of Dihomooxacalix[4]arene Phthalimides: NMR,X-ray and Photophysical Analysis §

Direct O-alkylation of p-tert-butyldihomooxacalix[4]arene (1) with N-(bromopropyl)- or N-(bromoethyl)phthalimides and K₂CO₃ in acetonitrile was conducted under conventional heating (reflux) and using microwave irradiation and ball milling methodologies. The reactions afforded mono- and mainly distal di-substituted derivatives in the cone conformation, in a total of eight compounds. They were isolated by column chromatography, and their conformations and the substitution patterns were established by NMR spectroscopy (¹H, ¹³C, COSY and NOESY experiments). The X-ray structures of four dihomooxacalix[4]arene phthalimide derivatives (2a, 3a, 3b and 5a) are reported, as well as their photophysical properties. The microwave (MW)-assisted alkylations drastically reduced the reaction times (from days to less than 45 min) and produced higher yields of both 1,3-di-substituted phthalimides (3a and 6a) with higher selectivity. Ball milling did not reveal to be a good method for this kind of reaction.     

Doxorubicin Encapsulation in Carbon Nanotubes Having Haeckelite or Stone–Wales Defects as Drug Carriers: A Molecular Dynamics Approach

Doxorubicin (DOX), a recognized anticancer drug, forms stable associations with carbon nanotubes (CNTs). CNTs when properly functionalized have the ability to anchor directly in cancerous tumors where the release of the drug occurs thanks to the tumor slightly acidic pH. Herein, we study the armchair and zigzag CNTs with Stone–Wales (SW) defects to rank their ability to encapsulate DOX by determining the DOX-CNT binding free energies using the MM/PBSA and MM/GBSA methods implemented in AMBER16. We investigate also the chiral CNTs with haeckelite defects. Each haeckelite defect consists of a pair of square and octagonal rings. The armchair and zigzag CNT with SW defects and chiral nanotubes with haeckelite defects predict DOX-CNT interactions that depend on the length of the nanotube, the number of present defects and nitrogen doping. Chiral nanotubes having two haeckelite defects reveal a clear dependence on the nitrogen content with DOX-CNT interaction forces decreasing in the order 0N > 4N > 8N. These results contribute to a further understanding of drug-nanotube interactions and to the design of new drug delivery systems based on CNTs.